Please review all the information below prior to making a purchase. Our team can assist with installation at all times.

Enterprise Series TV Enclosure - 50" Example

Indoor TV Overlay Kit

Internal Bracket KLC-X5 for Enterprise Series Enclosures 32" - 4

Internal Bracket S8 for Enterprise Series Enclosures 50" - 75"

Internal Bracket NX100 for Enterprise Series Enclosures 75", 86", 98" and 110"

Portrait Mode Setup

All enclosures are shipped by default in landscape mode

Landscape Mode
Logo aligned bottom middle centre
Rear side carry handles top right and top left
Power supply and power board right side mounted
Locks positioned southside underside of enclosure
IR is bottom left side for convenience
TV is installed left to right
Landscape mode is the traditional way of TV alignment

Portrait Mode
Enclosure needs to be rotated to the right side
Logo is now on the right side
IR is now located on the bottom right side
Power supply and power board is located at the top of the enclosure
Power supply and power board are to be OFF the bottom floor of the enclosure at all times – that means either east or north direction.
Portrait mode typically used for advertising

Switching between IP65 to IP56

By default the enclosure is IP65 certified. However there are interchangeable squares that are vented so you can allow more air flow. These vents open the enclosure up slightly so you can make a IP56 enclosure. The IP56 hot swap vents are inside the spare parts pack and clearly labelled. You can swap out all vents or just some, the choice is yours. Make sure in landscape mode the vents are facing the downward direction and the same direction in Portrait mode.